![]() Now, it turns out that there’s actually a neat and happy medium from (of all places) Radio Shack: A protoboard shaped and wired up like a breadboard. ![]() ![]() However, that’s an acquired skill, and there is indeed a bit of a leap from breadboard… It turns out that we don’t actually use solderless breadboards all that often– most of our physical prototyping is soldered directly on perfboards, like so: Basically what is the best way to do without a lot of rework? This will be my first time doing this and I was just wondering if there were any best practices so that the final product looks clean and organized and I don’t have mountains of solder on the back side.” ![]() Ryan writes in, “I have a question about moving a project off a bread board and onto a project or perf board.
0 Comments
Leave a Reply. |